The 820 Epoxy Laminating Systems are developed for the fabrication and repair of high performance composite structures. They consist of one resin and a selection of three separate hardeners to suit your building or repair needs. The resin and hardener combinations produce low viscosity mixtures with convenient volumetric mix ratios. In addition, the 820 Epoxy Laminating Systems are specially formulated for standard wet lay-up or resin-infusion operations requiring the highest degree of fabric wetting and air release attributes. The systems are specifically engineered to promote a high fiber-to-resin ratio and a greater interface with composite fabric(s), thereby resulting in lighter, stronger parts offering lower maintenance and long-term performance.

820 Epoxy Laminating Systems are UV stabilized, ultra low viscosity laminating system that is ideal for use in vacuum infusion processes or RTM applications. Use with Graphite, S-Glass, E-Glass or Kevlar fabrics. Produces strong, light weight composite parts. They are specially formulated for standard wet lay-up or resin-infusion operations requiring the highest degree of fabric wetting and air release attributes.

We recommend curing Adtech & our Nanotube Enhanced Resin between 85F and 160F. We have not tested above 200F and temp below 80F are not recommended due to very long cure times. The 820 and our nano resin will get thick when they get cold. If stored below 60F it may become semi-solid (this does not hurt the resin); if this occurs, put the can in front of a space heater and the resin will become thin and clear again. If you need a resin to cure below 77F, we recommend you consider West Systems below.

*****Please note - if you order the pumps, they are a 1 to 1 Ratio*****
We generally recommend you confirm the correct ratio with a scale, even if you use the pumps.

Carbon Nanotube Enhanced Epoxy Resin and

Available in combined or separate kits

World's Strongest Epoxy Resin
Our Carbon Nanotube Kits produce typical increase stiffness and breaking strength of 25%+

Carbon Nanotubes are 40X stronger than carbon fiber. You will very likely increase stiffness and breaking strength by well over 25% just by using this Nanotube resin!

Our carbon Nanotubes are added to the resin.

Customer comments: "results were fantastic"...."really bullet proof!"

Resin now come in convenient screw-top cans ...

UV Stable,

Very LOW VOC,

Nanotubes withstands temp beyond 200F+

Room Temp (80F+) or Post Cure,

Nanotubes Resin + Hardener, will not affect the clear appearance of your carbon fabric in standard thin coats (not intended for thick top coats)

 

Works great for vacuum bagged & hand lay-up applications (Nanotubes are not intended for infusion)

 

- Resin is consistence of a light syrup, a bit thicker than standard Adtech or West System Resin

- hardener is thin like water

- Not intended for use with pumps

- 5 parts resin to 1 part hardener (same as below).

- Results may vary, but it is likely you will get "better" results (tests were done using multiple layers of intermediate modulus carbon fiber; even better result should be achievable with aerospace grade carbon, commercial grade carbon, Kevlar, Fiberglass, Basalt, Innegra or other composite fabrics).

We recommend mixing resin before each use (the nano tubes will settle a bit over time).

Questions? Contact us! We make one of the world's lightest sporting goods with this resin.